Router Default Setting

Default Setting 4g Systems XSBox Move Router Login Username Password IP Address Modem Wi-Fi Network

4g Systems Default router settings, 4g Systems default WiFi settings, 4g Systems default gateway, 4g Systems default IP address

Find the default IP address and the password for the user interface of the 4g Systems XSBox Move 3G router. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.123.254 (or http://xsboxmove/)
Username:
<blank>
Password:
admin

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
default
Password:
<blank>

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the 4g Systems XSBox Move, you have to do the following steps for access:

  1. Put router into operation
  2. Establish a connection between the device and the router via network cable or Wi-Fi*
  3. Open web browser
  4. Paste IP address or URL in the address bar and then confirm with ‘Enter’ key
  5. Enter password in the open user interface and confirm again
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the 4g Systems XSBox Move to its default settings, you have to do the following steps:

  1. Put router into operation
  2. For at least 5 seconds, press the RESET button
  3. Device restarts automatically
  4. Router has been reset to factory settings

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.