Router Default Setting

7links PX-4892-919 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

7links Default router settings, 7links default WiFi settings, 7links default gateway, 7links default IP address

Here you will find the default IP address and the username and password for the user interface of the 7links PX-4892-919 WLAN WRP-630.wps router. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.0.1
Username:
admin
Password:
admin

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
starts with 7Links_PX-
Password:
on a sticker on the router’s case

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the 7links PX-4892-919, you have to do the following steps for access:

  1. Switch on router
  2. Set up a connection between the device and the router via Wi-Fi* or network cable
  3. Open web browser
  4. Insert IP address in the address bar and confirm with ‘Enter’ button
  5. Enter username and password in the open user interface and confirm again
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the 7links PX-4892-919 to its default settings, you have to do the following steps:

  1. Put router into operation
  2. Press RST button for at least 10 seconds
  3. Device is automatically restarted
  4. Router has been reset to factory settings

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.