7links PX-4911-919 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Here you will find the default IP address and the username and password for the user interface of the 7links PX-4911-919 300 Mbit WLAN router. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.
Login data for the user interface
- IP address:
- 192.168.1.1
- Username:
- admin
- Password:
- admin
Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings
- SSID:
- PX-4911
- Password:
- 12345678
Access to the user interface
Accessing the user interface is necessary when you want to change the router configuration. For the 7links PX-4911-919, you have to do the following steps for access:
- Put router into operation
- Set up a connection between the device and the router via Wi-Fi* or network cable
- Open browser
- Insert IP address into the address bar and confirm with ‘Enter’ key
- Enter username and password in the open user interface and confirm again
Reset default settings
Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.
Execute hardware reset
To reset the 7links PX-4911-919 to its default settings, you have to do the following steps:
- Put router into operation
- For at least 10 seconds, press the WPS/Reset button
- Device is automatically restarted
- Default settings have been restored
Execute software reset
With the 7links PX-4911-919, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.
Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.