Router Default Setting

Default Setting Allied Telesis AT-WR2304N Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

allied telesis Default router settings, allied telesis default WiFi settings, allied telesis default gateway, allied telesis default IP address

Here you will find the default IP address and the username and password for the user interface of the Allied Telesis AT-WR2304N 300Mbps Wireless router. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.1.1
Username:
manager
Password:
friend

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

No wireless networks are preconfigured for this device.

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Allied Telesis AT-WR2304N, you have to do the following steps for access:

  1. Switch on router
  2. Establish a connection between the device and the router via network cable or Wi-Fi*
  3. Start web browser
  4. Enter IP address in the address bar and then confirm with ‘Enter’ key
  5. Enter username as well as password in the login form and confirm
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Allied Telesis AT-WR2304N to its default settings, you have to do the following steps:

  1. Switch on router
  2. Press and hold the Reset button until the router’s Power LED flashes
  3. Device restarts automatically
  4. Default settings have been restored

Execute software reset

With the Allied Telesis AT-WR2304N, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.