Router Default Setting

Default Setting Amped Wireless RTA1750 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

amped wireless Default router settings, amped wireless default WiFi settings, amped wireless default gateway, amped wireless default IP address

Here you will find the default IP address and the predefined access data for the user interface of the RTA1750 High Power AC1750 Wi-Fi router of Amped Wireless. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.3.1 (or http://setup.ampedwireless.com)
Username:
<blank>
Password:
<blank>

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
Amped_RTA1750_
Password:
wireless

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Amped Wireless RTA1750, you have to do the following steps for access:

  1. Switch on router
  2. Set up a connection between the device and the router via Wi-Fi* or network cable
  3. Open web browser
  4. Paste IP address or URL in the address bar and then confirm with ‘Enter’ key
  5. Enter password in the open user interface and confirm again
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Amped Wireless RTA1750 to its default settings, you have to do the following steps:

  1. Put router into operation
  2. Press Reset button for at least 10 seconds
  3. Restart of the device is automatically executed
  4. Restoration of standard settings is finished

Execute software reset

With the Amped Wireless RTA1750, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.