Router Default Setting

Default Setting ARRIS SBG7400AC2 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

arris Default router settings, arris default WiFi settings, arris default gateway, arris default IP address

Here you will find the default IP address and the username and password for the user interface of the ARRIS SBG7400AC2 SURFboard® Cable Modem & Wi-Fi router. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.0.1
Username:
admin
Password:
password

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
on a sticker on the router’s case
Password:
on a sticker on the router’s case

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the ARRIS SBG7400AC2, you have to do the following steps for access:

  1. Switch on router
  2. Set up a connection between the device and the router via Wi-Fi* or network cable
  3. Open browser
  4. Insert IP address in the address bar and confirm with ‘Enter’ button
  5. Enter username and password in the open user interface and confirm again
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the ARRIS SBG7400AC2 to its default settings, you have to do the following steps:

  1. Switch on router
  2. Press Reset button and hold for at least 10 seconds
  3. Device restarts automatically
  4. Router has been reset to factory settings

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.