Router Default Setting

Default Setting AVM FRITZ!Box 7390 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

avm Default router settings, avm default WiFi settings, avm default gateway, avm default IP address

Here you will find the default IP address and the predefined access data for the user interface of the FRITZ!Box 7390 WLAN router of AVM. This site also provides information about the preconfigured Wi-Fi settings of the device. In the bottom part of this site, you will find a manual for accessing the router’s user interface.

Login data for the user interface

IP address:
169.254.1.1 (or http://fritz.box/)
Username:
<blank>
Password:
<blank>

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
FRITZ!Box Fon WLAN 7390
Password:
on a sticker on the router’s case

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the AVM FRITZ!Box 7390, you have to do the following steps for access:

  1. Switch on router
  2. Connect the device via Wi-Fi* or a network cable with the router
  3. Start web browser
  4. Insert URL or IP address into the address bar and confirm with ‘Enter’ key
  5. Enter password in the open interface and confirm once more
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute software reset

With the AVM FRITZ!Box 7390, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.