Router Default Setting

Belkin F5D5231-4 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Here you will find the default IP address and the predefined access data for the user interface of the F5D5231-4 Cable/DSL Gateway router of Belkin. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.2.1
Username:
<blank>
Password:
<blank>

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Belkin F5D5231-4, you have to do the following steps for access:

  1. Switch on router
  2. Connect the device via network cable with the router
  3. Open browser
  4. Insert IP address in the address bar and confirm with ‘Enter’ button
  5. Enter password in the open interface and confirm once more

This router can also be configured with the provided software.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Belkin F5D5231-4 to its default settings, you have to do the following steps:

  1. Turn on router
  2. Press reset button and hold for at least 5 seconds
  3. Device is automatically restarted
  4. Router has been reset to factory settings

Execute software reset

With the Belkin F5D5231-4, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.