Router Default Setting

Belkin F5D8231-4 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Here you will find the default IP address and the predefined access data for the user interface of the F5D8231-4 N1 Wireless router of Belkin. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.2.1
Username:
<blank>
Password:
<blank>

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
starts with Belkin_N1_Wireless
Password:
<blank>

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Belkin F5D8231-4, you have to do the following steps for access:

  1. Switch on router
  2. Establish a connection between the device and the router via network cable or Wi-Fi*
  3. Open web browser
  4. Insert IP address in the address bar and confirm with ‘Enter’ button
  5. Enter password in the open user interface and confirm again

This router can also be configured with the provided software.

* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Belkin F5D8231-4 to its default settings, you have to do the following steps:

  1. Switch on router
  2. For at least 10 seconds, press the Reset button
  3. Device restarts automatically
  4. Router has been reset to factory settings

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.