Router Default Setting

Belkin RT1800 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Find the default IP address and the password for the user interface of the Belkin RT1800 AX1800 WiFi 6 router. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.1.1 (or https://myrouter.local)
Username:
<blank>
Password:
admin

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
starts with Belkin
Password:
on a sticker on the router’s case

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Belkin RT1800, you have to do the following steps for access:

  1. Switch on router
  2. Set up a connection between the device and the router via Wi-Fi* or network cable
  3. Start web browser
  4. Paste IP address or URL in the address bar and then confirm with ‘Enter’ key
  5. Enter password in the open interface and confirm once more
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Belkin RT1800 to its default settings, you have to do the following steps:

  1. Turn on router
  2. Press Reset button and hold for at least 10 seconds
  3. Device restarts automatically
  4. Restoration of standard settings is finished

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.