Router Default Setting

Buffalo WHR-300HP Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Here you will find the default IP address and the username and password for the user interface of the Buffalo WHR-300HP N300 DD-WRT WLAN router. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.11.1
Username:
admin
Password:
password

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
on an information card that comes with the router
Password:
on an information card that comes with the router

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Buffalo WHR-300HP, you have to do the following steps for access:

  1. Put router into operation
  2. Connect the device via Wi-Fi* or a network cable with the router
  3. Open web browser
  4. Insert IP address into the address bar and confirm with ‘Enter’ key
  5. Enter username as well as password in the login form and confirm
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Buffalo WHR-300HP to its default settings, you have to do the following steps:

  1. Switch on router
  2. Press Reset button for at least 3 seconds
  3. Device restarts automatically
  4. Router has been reset to factory settings

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.