Router Default Setting

Genexis DRG7820 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Here you will find the default IP address and the predefined access data for the user interface of the DRG7820 WiFi FTTH router of Genexis. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.1.254 (or https://router)
Username:
admin
Password:
on a sticker on the router’s case

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
starts with GNX
Password:
on a sticker on the router’s case

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Genexis DRG7820, you have to do the following steps for access:

  1. Put router into operation
  2. Connect the device via Wi-Fi* or a network cable with the router
  3. Start web browser
  4. Insert IP address or URL into the address bar and confirm with ‘Enter’ button
  5. Enter username and password in the open interface and confirm once more
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Genexis DRG7820 to its default settings, you have to do the following steps:

  1. Switch on router
  2. Press the Reset button until all of the router’s LEDs flash
  3. Device restarts automatically
  4. Router has been reset to factory settings

Execute software reset

With the Genexis DRG7820, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.