Router Default Setting

Genexis Platinum-7840 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Here you will find the default IP address and the predefined access data for the user interface of the Platinum-7840 WiFi Cable VoIP router of Genexis. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.1.254 (or http://router)
Username:
admin
Password:
on a sticker on the router’s case

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
starts with GNX
Password:
on a sticker on the router’s case

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Genexis Platinum-7840, you have to do the following steps for access:

  1. Put router into operation
  2. Connect the device via Wi-Fi* or a network cable with the router
  3. Open browser
  4. Insert URL or IP address into the address bar and confirm with ‘Enter’ key
  5. Enter username and password in the open interface and confirm once more
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Genexis Platinum-7840 to its default settings, you have to do the following steps:

  1. Put router into operation
  2. Press Reset button and hold for at least 6 seconds
  3. Device restarts automatically
  4. Restoration of standard settings is finished

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.