Router Default Setting

LANCOM 1631E Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Here you will find the default IP address and the predefined access data for the user interface of the 1631E Gigabit Ethernet router of LANCOM. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
172.23.56.254
Username:
<blank>
Password:
<blank>

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the LANCOM 1631E, you have to do the following steps for access:

  1. Turn on router
  2. Set up a connection between the device and the router
  3. Open browser
  4. Insert IP address into the address bar and confirm with ‘Enter’ key
  5. Enter password in the open user interface and confirm again

This router can also be configured with the provided software.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the LANCOM 1631E to its default settings, you have to do the following steps:

  1. Put router into operation
  2. Press Reset button for at least 6 seconds
  3. Restart of the device is automatically executed
  4. Restoration of standard settings is finished

Execute software reset

With the LANCOM 1631E, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.