Router Default Setting

Netgear DM111PSP Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Here you will find the default IP address and the username and password for the user interface of the Netgear DM111PSP ADSL2+ Modem router. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.0.1 (or http://www.routerlogin.net)
Username:
admin
Password:
password

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Netgear DM111PSP, you have to do the following steps for access:

  1. Turn on router
  2. Establish a connection between the device and the router via network cable
  3. Open web browser
  4. Paste IP address or URL in the address bar and then confirm with ‘Enter’ key
  5. Enter username as well as password in the login form and confirm

This router can also be configured with the provided software.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Netgear DM111PSP to its default settings, you have to do the following steps:

  1. Put router into operation
  2. For at least 10 seconds, press the Reset button
  3. Device restarts automatically
  4. Router has been reset to factory settings

Execute software reset

With the Netgear DM111PSP, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.