Router Default Setting

Sitecome WLR-3000 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Here you will find the default IP address and the predefined access data for the user interface of the WLR-3000 Wi-Fi Broadband router of Sitecome. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.0.1
Username:
admin
Password:
on a sticker on the router’s case

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

No wireless networks are preconfigured for this device.

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Sitecome WLR-3000, you have to do the following steps for access:

  1. Switch on router
  2. Establish a connection between the device and the router via network cable or Wi-Fi*
  3. Open web browser
  4. Insert IP address into the address bar and confirm with ‘Enter’ key
  5. Enter username as well as password in the login form and confirm
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Sitecome WLR-3000 to its default settings, you have to do the following steps:

  1. Put router into operation
  2. Press WPS button for at least 15 seconds
  3. Device restarts automatically
  4. Default settings have been restored

Execute software reset

With the Sitecome WLR-3000, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.