Router Default Setting

Telekom Speedport Smart Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Here you will find the default IP address and the predefined access data for the user interface of the Speedport Smart Wireless VoIP router of Telekom. This site also provides information about the preconfigured Wi-Fi settings of the device. In the bottom part of this site, you will find a manual for accessing the router’s user interface.

Login data for the user interface

IP address:
192.168.2.1 (or http://speedport.ip)
Username:
<blank>
Password:
on an information card that comes with the router

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
on an information card that comes with the router
Password:
on an information card that comes with the router

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Telekom Speedport Smart, you have to do the following steps for access:

  1. Turn on router
  2. Set up a connection between the device and the router via Wi-Fi* or network cable
  3. Open browser
  4. Paste IP address or URL in the address bar and then confirm with ‘Enter’ key
  5. Enter password in the open user interface and confirm again
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute software reset

With the Telekom Speedport Smart, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.