Tenda F9 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Here you will find the default IP address and the predefined access data for the user interface of the F9 600M Wi-Fi router of Tenda. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.
Login data for the user interface
- IP address:
- 192.168.0.1 (or http://tendawifi.com)
- Username:
- <blank>
- Password:
- <blank>
Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings
- SSID:
- starts with Tenda
- Password:
- <blank>
Access to the user interface
Accessing the user interface is necessary when you want to change the router configuration. For the Tenda F9, you have to do the following steps for access:
- Turn on router
- Connect the device via Wi-Fi* or a network cable with the router
- Open browser
- Insert IP address or URL into the address bar and confirm with ‘Enter’ button
- Enter password in the login form and confirm
Reset default settings
Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.
Execute hardware reset
To reset the Tenda F9 to its default settings, you have to do the following steps:
- Turn on router
- For at least 8 seconds, press the WPS/RST button
- Device restarts automatically
- Router has been reset to factory settings
Execute software reset
With the Tenda F9, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.
Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.