Router Default Setting

Tenda FH456 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Here you will find the default IP address and the predefined access data for the user interface of the FH456 300Mbps Wireless N Smart Router router of Tenda. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.0.1
Username:
<blank>
Password:
<blank>

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
Tenda_
Password:
in the documents that come with the router

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Tenda FH456, you have to do the following steps for access:

  1. Switch on router
  2. Set up a connection between the device and the router via Wi-Fi* or network cable
  3. Open web browser
  4. Insert IP address in the address bar and confirm with ‘Enter’ button
  5. Enter password in the open user interface and confirm again
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Tenda FH456 to its default settings, you have to do the following steps:

  1. Turn on router
  2. Press the RST button until all of the router’s LEDs flash
  3. Device restarts automatically
  4. Default settings have been restored

Execute software reset

With the Tenda FH456, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.