Router Default Setting

TP-LINK Archer MR600 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Here you will find the default IP address and the predefined access data for the user interface of the Archer MR600 4G+ Cat6 AC1200 Wireless router of TP-LINK. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.1.1 (or http://tplinkmodem.net)
Username:
<blank>
Password:
<blank>

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
on a sticker on the router’s case
Password:
on a sticker on the router’s case

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the TP-LINK Archer MR600, you have to do the following steps for access:

  1. Switch on router
  2. Connect the device via Wi-Fi* or a network cable with the router
  3. Start web browser
  4. Insert IP address or URL into the address bar and confirm with ‘Enter’ button
  5. Enter password in the login form and confirm
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the TP-LINK Archer MR600 to its default settings, you have to do the following steps:

  1. Turn on router
  2. Press and hold the WPS/RESET button until the router’s Power LED flashes
  3. Device is automatically restarted
  4. Default settings have been restored

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.