Router Default Setting

TRENDnet TEW-690AP Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Here you will find the default IP address and the predefined access data for the user interface of the TEW-690AP N450 WiFi router of TRENDnet. This site also provides information about the preconfigured Wi-Fi settings of the device. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.10.100
Username:
admin
Password:
<blank>

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

SSID:
TRENDnet690
Password:
<blank>

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the TRENDnet TEW-690AP, you have to do the following steps for access:

  1. Put router into operation
  2. Establish a connection between the device and the router via network cable or Wi-Fi*
  3. Open browser
  4. Enter IP address in the address bar and then confirm with ‘Enter’ key
  5. Enter username in the login form and confirm

This router can also be configured with the provided software.

* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the TRENDnet TEW-690AP to its default settings, you have to do the following steps:

  1. Put router into operation
  2. Press Reset button and hold for at least 10 seconds
  3. Device is automatically restarted
  4. Default settings have been restored

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.