Router Default Setting

ZyXEL NBG-419N v2 Router Login Username Password IP Address Modem Wi-Fi Broadband Default Setting

Default router settings, default WiFi settings, default gateway, default IP address

Find the default IP address and the password for the user interface of the ZyXEL NBG-419N v2 Wireless N300 NetUSB router. Below you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.1.1
Username:
<blank>
Password:
1234

Preconfigured [Preset, Preinstalled, Built-in] Wi-Fi settings

No wireless networks are preconfigured for this device.

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the ZyXEL NBG-419N v2, you have to do the following steps for access:

  1. Put router into operation
  2. Set up a connection between the device and the router via Wi-Fi* or network cable
  3. Open browser
  4. Enter IP address in the address bar and then confirm with ‘Enter’ key
  5. Enter password in the open user interface and confirm again
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting to default settings is particularly useful if you've changed and forgotten the login credentials for the user interface. Please note that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the ZyXEL NBG-419N v2 to its default settings, you have to do the following steps:

  1. Put router into operation
  2. Press RESET button and hold for at least 5 seconds
  3. Restart of the device is automatically executed
  4. Default settings have been restored

Execute software reset

With the ZyXEL NBG-419N v2, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

Once you have successfully completed the steps above, the router's configuration will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.